Fire

This article provides instructions for exporting and saving the program from an FPA-1000 to be imported into a replacement FPA-1000 panel. This information may be needed when replacing an FPA-1000 fire panel with another with intentions to use the same panel program.

This article explain how it is possible to automatically zoom in the map in case of alarm.

Follow the steps from this article to access the Point Description programming.

Part numbers FPA-1000, FPA-1000UL, FPA-1000-V2

Follow this step-by-step guide from this article and find out how to stop and restart the FSM Server service

This article provides instructions for troubleshooting Ground Fault in the FPD-7024 or D7024

Follow this step-by-step guide and learn how you can use keypad programming to configure FPD-7024 IP communications

Library is offering 3 different sizes of detectors and can be customized. See this article and find out how you can customize Symbols (icons) - FSM

Follow the steps from this article to see the labels from the sensors in FSM which are configured in RPS

This article is a step by step guide about how to create panel container on map by using Macro-Area (point) on FMS.

To silence all NAC's of one panel (FPA-5000/Avenar) from the map in FSM Step-by-step guide   Insert a sensor on the map of FSM Under sensor properties choose: General: Add symbol: FIRE_Panel_FPA_BG Settings: Driver Instance: the panel / compound where the FSM is belongs to Address-> e.g. Panel 1-10.1 ! Please pay attention: there are other “Panel” possibilities to choose. Please do not choose Panel 1-10 (Communication)! After inserting the settings click “ok” Then Apply At the map when you right click the panel symbol you will get the commands as shown below.   If there is a fire alarm, you can right click at the panel and then click at “silence on”. Please be sure, that then every NAC which is belonging to this panel is “silenced”. Additional: there is also a command "silence scope" which then has the effect, that the whole scope will be silenced.

This article explains step by step how to enable commands for operator (other than admin) in FSM

Have a look at this article and see how you can setup the FMS - OSD Logo

Learn from this article how to enable usage type Fire on KD55 element from Bosch Remote Programming Software (RPS)

Follow this article and learn about the option which allows you to configure the color for each state & sensor in FSM

Live time event printing is supported. To enable it, add a xml file in program data folder with the name of the printer.

This feature blocks the programming feature through the keypad of the FPD-7024. This feature is only enabled via RPS.   Step-by-step guide   1 Connect to the Panel via RPS an Open the FPD-7024 programming sheet.   2 Go into Program Accounts and Remote Access Security.   3 Open Anti-takeover Setting and Select "Lock all local programming (except Date/Time and all user PINs)" to block the programming via keypad of the panel.  

This article contains a step-by-step guide about how you can set the field of view (FoV) of AVIOTEC IP starlight 8000

This article explain what should be done if new detectors are added to the system. 

This article presents step by step how to configure the “E-Mail Sender” function in FSM.