The controller is showing faults but when you access the faults option no errors/fault messages are shown, message 'no suitable element' is shown. Why?
This feature blocks the programming feature through the keypad of the FPD-7024.
This feature is only enabled via RPS.
Step-by-step guide
1 Connect to the Panel via RPS an Open the FPD-7024 programming sheet.
2 Go into Program Accounts and Remote Access Security.
3 Open Anti-takeover Setting and Select "Lock all local programming (except Date/Time and all user PINs)" to block the programming via keypad of the panel.
The operator 10000 is shown when detector fault/ Fire is acknowledged on the controller when no operator is logged in (e.g. Operator 2), by pressing the Acknowledge button.
The following steps describe an efficient way to update the panel firmware in an AVENAR panel 4.x network via SD card, thus keeping downtime of the panels to a minimum. To further reduce downtime, it is recommended to network the panel nodes via ETH.