How to troubleshoot the 2000 series panel when the keypad reads Call For Service.
My D2212 reads "Call For Service" and does not show anything else. How do I determine the issue?
D2212, D2412, D2812
Issue
Will an Answering Machine cause the D168A not to answer when accessed locally?
Solution
Some answering machines load down the phone line and cause it to go below 7 VDC. The D168A needs at least 7 VDC to properly process the DTMF tones.
Issue
What handler is used to program the D2812 panel.
Solution
The D5200 2212 product handler supports the following panels: D2212, D2212B, D2212BE, D2412, D2412U, D2812, D2812U.
Issue
What is the difference between the D133 an D134?
Solution
The D133 has a single relay rated at 2A @ 30 VDC – 0.6A @ 125 VAC.
The D134 has two relays rated at 2A @ 30 VDC – 0.6A @ 125 VAC.
Current draw for the Relay is 40 mA per relay when activated.
How to initiate a programmed test time on 2000 Series control panels.
Does the D2212 Timer Test Need to be Initiated from the Keypad?
D2812,D220A (8 led),D2412,D2212,D222A LCD,D223A LCD,D220A,D222,D223
Issue
How can I setup Open/Close on a 2000 series panel?
Solution
Using RPS/RAMIV
1. Connect to the control via modem/RPS and receive all panel data and save to your RPS database.
2. Go to the Reports section of the program.
A. Turn on All-On reports by selecting Yes.
B. Turn on Part-On reports by selecting Yes.
3. Save your changes and send the changed data back to the control. Test it out.
Using 5200
1. Latch the installer clip on the control panel and receive a fresh copy of the panel data.
2. After you see Receive Successful on your 5200, go to the Reports section of the program.
3. Using the white SPACE bar on the 5200 press it to toggle NO to YES to turn on O/C for both ALL ON and PART ON.
4. Press the red SEND LOAD key, disconnect the programmer and unclip the installer switch. Test it out.
