Security: Intrusion

Configure Remote Security Control Related Products Remote Security Control RPS Remote Programming Software B4512 B5512 B6512 B8512G B9512G D7212GV4 D7412GV4 D9412GV4

  The Standby (Reset) pin is not locked down. The panel 12V backup battery is low or missing. Using the wrong product handler, for example, using 2112 instead of 2212. Too much Current Draw on panel. Disconnect devices from Aux Power and try again. Noise or interference on the keypad Data Bus. Disconnect all wires on the panel data terminals. Not enough free memory in the D5200 Programmer. There should be 60K free memory. Refer to KB article: How to Operate the D5200 Hand Held Programmer. The 2212 handler may be corrupted in the D5200. Delete the 2212 handler and re-download it. Refer to KB article: How to Operate the D5200 Hand Held Programmer. Low batteries in the D5200. Replace batteries using 4 C cells. Trying to program a panel that is not powered up The programming cord is not securely connected to the panel programming port or may be damaged. The DX4010V2 comes with a cord with a 4-pin Molex connector on one end and phone connector on other end. This cable may work as a substitute.

The B8512 or B9512 supervises keypads even when Supervision=NO Related Products B8512 B9512 B915 B920 B921C B925F  B926F B930 B942

Cannot silence an alarm when using the Custom Function set to Disarm Related Products B3512 B4512 B5512 B6512 B8512G B9512G D7412GV4 Ver2+ D9412GV4 Ver2+

The panel will not send alarm reports and instead is sending an 'ALARM RECENT CLS’ event.

The B8512 or B9512 supervises keypads even when disabled Related Products B8512 B9512 B915 B920 B921C B925F  B926F B930 B942    Overview   Issue The B8512 or B9512 supervises keypads even when Supervision=NO   Solution    If the keypad Type is set to an SDI type keypad (see below) the supervision setting can be configured YES or NO.  When the keypad Type is set to one of the SDI2 type keypads the supervision Yes/No setting is ignored and the keypad is supervised.   SDI2 devices are always supervised by design regardless of the supervision setting.   SDI Keypads  SDI2 Keypads  D1255 VFD Keypad (SDI)  B915  D125xRB Keypad (SDI)  B920  D126x LCD Keypad (SDI)  B921C    B925F    B926F    B930    B942 Notes SDI2 devices that are the same type of device must use different addresses. SDI2 devices that are not the same type can be configured to the same address.  For example: The B915, B92x, B930 or B942 are all same device types (keypads) and must use different addresses. The B920, B208 and B520 are all different device types and can all use the same address.

If you do not know the IP or MAC for the D6682 and are unable to get in to setup with Telnet.

Using Menu Shortcuts or Menu Commands on G Series and New G Series panels.

Instructions for adding, changing and general managing passcodes in 2000 Series control panels.

After adding the RFUN-A Universal Transmitter, the point always shows faulted even though it’s normal.

How to enable telnet in windows 7 or 8 or 10 Related Products Windows 8 Windows 7 Windows Vista Windows XP Telnet Client Conettix DX4020 C900V2 D6682 D6680