The password for the local admin and diagnostic port is set to the same starting with E2800 controller firmware 11.40.2 or later.
In case a user does not know his password any longer, it is not possible to reset and re-configure this password by using the diagnostic port (serial port on the rear side near the uplink ports of the controller). With controller firmware older than 11.40.2 it was possible to reset the Administrator Password needed for configuration. But older NetApp controller firmware cannot and must not be used any longer due to other technical reasons. When accessing the Management Port IP to enter the WEB GUI of the NetApp E2800 system for configuraiton or support data collection, the Administrator Password is required. For the time being this is reported to NetApp to work out a solution for all NetApp customers and BOSCH.
Solution and Procedure:
Right now, BOSCH and our customers have no documented instruciton or procedure to remove / reset the password. We are working ont hat with high preassure and awareness. We kindly ask all customers requiring access to the configuraiton but having not the Administrator Password on hand for configuraiton, to reach out to BOSCH support and ask to sent the requewst immediately up to a Levle 3 Ticket to the Gatekeeper team at BOSCH BT-SC/ETP-MKP2 or BT-VS Support in the BU.