How to use Camera Trainer

[#1]

Upcoming with FW 7.10 and CM 6.20, Camera Trainer is a licensable Intelligent Video Analytics module that allows uses to define objects of intereste and train their own detectors for them based on examples of target objects and non-target objects. In contrast to the moving objects detected in general by IVA 7.10, Camera Trainer allows detection of both moving and non-moving objects, separates and immediately classifies them. Training can be done both on live video as well as on recordings available through the respective camera. The resulting detectors can be down- and uploaded for distribution to other cameras.

Camera Trainer configuration should be done in Configuration Manager.

The attached fact sheet lists the cameras that support Camera Trainer. The attached technical note describes in-depth what Camera Trainer is, how it works, what to use it for and what not, and how to configure it. The configuration is also shown in the following how-to videos:

Note: After you license your Camera Trainer, reboot your device.

Setup Camera Trainer

Camera learning phase with recorded video

Configure Camera Trainer Task

Backup Camera Trainer Configuration - Method 1

Backup Camera Trainer Configuration - Method 2

Setup VCA Masking

[AlexAlex66]

Camera NIN-70122-F0A + CM6.2 Demo license (Camera Trainer) activated In the menu CM6.2-> VCA -> Camera Trainer, the tabs are locked What am I doing wrong?

[Galina]

The reason for locked tabs is that CM thinks someone else is configuring the camera. Recovery is typically possible by switching to another camera and back, or restarting CM.

[ogr1ml]

May I ask is the camera trainer can also be configured in BVMS 10 or 10.0.1

[Galina]

Camera Trainer configuration should be done in Configuration Manager.