Depending on the FW version of cameras and BVMS version you have installed, different possible situations can occur such as: the cameras are not working because the firmware is old, Configuration Client will display a message like: "unknown platform", Gaps in recordings or not recording at all and so on
To ensure the highest customer satisfaction and replace the defective hardware faster and more smoothly, it is necessary to register each system for the specific country together with the system location.
But where and why should you register your device?
Find out from this article how to configure a singe mode VIF on NetApp array. For example if we have 2 (or more) physical interfaces, how to connect them to different network segments and, if one of the segments fails, the second network interface to step in automatically?
BP+ (Baseline Profile +) is available in any of the new ARM based chipset encoders, like the VIP-X1 XF. BP+ is needed for compatibility with Divar and hardware decoders, for example, theVIP XD decoder.
The attached manual provides information for Mobile Video Service (MVS) within Bosch Video Management System.
You can find: - how to configure the router and Internet Information Service (IIS) - how to add MVS to BVMS - user guide - some troubleshooting tips
This document can also be found online here.
This article describes the different components that Bosch Video Management System offers to to establish a connection between Bosch Video Management System and a 3rd party management system.
This description helps you in writing your own commands for controlling Bosch VMS from inside your management system.