Security: Video

This article contains videos which explain the usage of Bosch cameras integrated in Genetec Security Center.

Once installed and licensed, an application can also be uninstalled from the camera. In this case, the license is being returned to the license pool. It can then be installed on another device. Please note: no return option is possible for the *complete offline use case.

This article provides possible causes and solutions regarding FLEXIDOME Inteox 7100i (CPP13) - calibration lost using FW 8.45.0032.

This article contains the steps to focusing a Bosch Box camera: set the Back Focus to the Center position and focus on a specific area

Essential Video Analytics (VCA) does not work as soon as the image is rotated to 90 degrees (under Initialization) and the camera is restarted. Additionally, the movements or objects are not recognized. As soon as you set "Rotate image" to 0 degrees and set it back to 90 degrees, motion detection via Essential Video Analytics suddenly works again.

You can call desired pre-positions (PTZ) of Bosch IP cameras by using OSRD protocol or BiCom protocol. Please check this aticle to find some examples and detailed explanation.

After configuring the Virtual mask in the web browser of Bosch CPP7.3 camera and afterwards going back to the Live view, the Virtual mask appears as Privacy mask and is not transparent and other inappropriate behaviors have been noticed. This happens on the Bosch CPP7.3 cameras that have FW version older than v.7.86.0019

This article presents what parameters to set in BVMS on a new Stream Quality profile.

All Bosch IP cameras that are equipped with a Micro SD can record at the edge. While video recorded via Bosch’s proprietary iSCSI format is none readable, many sites require any type of recorded video to be encrypted.

WD MSD-064G IP SECURITY MICROSD CARD does not support lifespan check for Bosch CPP4 cameras

To get a snapshot image from your camera, you can use the following URL: HTTP://camera_IP_address/snap.jpg

Starting on September 30th 2021, Dropbox™ has changed to short-lived access tokens, which expire after four hours. 

This articol answer answer to the question:  Is the 'Day-to-night switch over' option missing in some Bosch cameras?

This article explain step by step how to upgrade the firmware for multiple cameras (bulk) at the same time in Configuration Manager.

This article explains how to switch a Bosch camera managed by a VRM to record to the SD card without factory defaults.

When the camera operates in automatic Night-Mode and the switching interval is too fast the camera built in protection mechanism will intervene to prevent premature wear of the mechanical IR-Cut filter.

After upgrading the camera firmware to version 7.81.0060 and higher, the camera display name become smaller in the font size. This is observed in CPP 6 and CPP 7 Bosch IP cameras.

Follow the steps below and find out how you can perform the Firmware Upgrade for multiple cameras in bulk

This article gives you the solution to fix the behavior when the recording doesn't work for VG4 AutoDome camera and when the Bosch logo is displayed in the cameo

Follow this step-by-step guide and learn how you can ground the parapet mount for Bosch IP cameras & POE Midspan