Related Products: Bosch Video Analytics for Firmware 6.40 and above
This article contains how to Videos that explain what calibration is, why and in which cases is it necessary to calibrate the camera and how to calibrate and verify the calibration.
Camera Calibration Introduction
This Video should help you to understand, what calibration means, why and when to calibrate the cameras.
Camera Calibration Paramenters
Understanding the calibration parameters.
DINION and FLEXIDOME camera calibration specifics
Specific calibration methods based on camera sensors for DINION and FLEXIDOME camera family.
Bosch Security - Video Analytics - Moving cameras calibration specifics
Specific calibration methods based on camera sensors, moving camera family.
Panoramic cameras calibration specifics
Specific calibration methods based on camera sensors, panoramic camera family.
Manual calibration, sketch calibration
Calibrate the camera using the measured values or with the help of calibration elements. Verify if the camera perspective about the scene is accurate.
Calibration verify function
How to verify if the camera perspective about the scene is accurate.
... View more
In December 2017 information about two vulnerabilities in modern processors were published. These exploits are often referred to as Meltdown and Spectre. Due to the nature of the flaw, many processors(AMD, ARM, Intel, etc.) are considered vulnerable. In order to use the exploit, an attacker needs to execute malicious code on the target system. It is thus generally advised to protect systems from unauthorized access (e.g. by using a strong password policy). BOSCH IP Cameras and BOSCH Encoders are based on Common Product Platform (CPP) designs. Each CPP uses a specific System-on-Chip (SOC), or a family of SoC’s, which inherit various CPU cores. Some of them include ARM cores, which are considered vulnerable. We therefore have analyzed our Common Product Platforms if they are affected, with the result: • Our Common Product Platforms CPP-ENC, CPP3 and CPP4 are not affected by the vulnerabilities. • The processors used in the SoC’s of our Common Product Platforms CPP6, CPP7 and CPP7.3 are affected. As we do not allow 3rd party code being installed or executed on our cameras, successful exploitation is considered not possible with Meltdown or Spectre. In short, our IP cameras and encoders are not vulnerable to Meltdown or Spectre exploitations. In general we recommend to always keep your device Firmware up to date.
... View more
In the Manual of the VideoJet decoder 8000 at Point 6.1: Setting up the decoder with Configuration Manager Before you can operate the unit within your network, it must have a valid IP address for your network and a compatible subnet mask. Notice! As a default DHCP is enabled in the unit’s network settings. With an active DHCP server in the network you must know the IP address assigned by the DHCP server to operate the unit. The following default address is preset at the factory: 192.168.0.1 The correct inital IP address is: 192.168.0.200
... View more