When the camera operates in automatic Night-Mode and the switching interval is too fast the camera built in protection mechanism will intervene to prevent premature wear of the mechanical IR-Cut filter.
According to its Data Sheet, the Flexidome IP 3000i IR camera has 2 options to activate the alarm input.
Please refer to the diagram from this article if you would like to get alarm input from some physical sensors.
After upgrading the camera firmware to version 7.81.0060 and higher, the camera display name become smaller in the font size. This is observed in CPP 6 and CPP 7 Bosch IP cameras.
*Firmware 9.10 must be installed prior to installation of this firmware 9.51.
Firmware download location: Download Store or on the product page > Downloads: VIDEOJET decoder 8000 page
This article aims to define the way you can display camera video via decoders. Moreover, fifteen different settings scenarios and their effects will be outlined for the live video to be displayed through the decoder.
This article explains how you can monitor the hardware health status of the DIVAR IP storage devices → Measure can be taken to repair the device if something fails.
⚠️ NOTE: This procedure is the same for all 2U and 3U systems and is also applicable for DIP 7000 AIO GEN3 , except 3108 FW might be different, depends on the exact model.
