Perform these steps to enable the D7024, FPD-7024, DS9400, DS9400I, and DS9400M for RPS programming via phone line with a compatible RPS modem:
- Press (0) Enter Program Mode.
- Enter Pin (Default is 9876).
- Press (6) Accounts.
- Press (4) Ring Count.
- Set Ring Count to (02) #.
- Press the (*) key two times or until you see PROGRAM MODES.
- Press (3) System.
- Press (7) Remote Program.
- Press (1) Enable.
- Press the (*) key five times to Exit Program Mode.
- You need to dial Line 1 on the panel. It is the second line down on the panel (it is NOT the line in the top right).
- Before connecting with RPS, perform an Auto-Learn with at least one Mux Device connected to the Mux loop, then send your RPS program to the panel.
- Press (0) Enter Program Mode.
- Enter Pin (default is 9876).
- Press (9) Program Mux.
- Press (4) Auto Program.
- Press (1) Yes.
