Issue
Programming in the phone number that the panel will dial for reporting.
Solution
The telephone number the panel dials to contact the central station receiver when sending event reports. Enter up to 24 of the following characters to define dialing characteristics.
The panel is pre-programmed with a 7-second dial tone detect period. When dial tone is detected or the waiting period ends, the panel begins to dial. To extend the dial tone detect program, place a D before the phone number. To insert a pause during or after dialing, use C in the number sequence. For example, if the panel hangs up before it hears the Modem IIIa2 ™ ack tone from the D6500, program extra Cs after the phone number. The panel waits on line for three extra seconds for each C programmed.
The first line of the phone number data entry line must be filled (12 characters) before you press ENTER to move on to the second line. If you enter characters on the second line, and there are less than 12 characters on the first line, the second line clears when you press ENTER.
IMPORTANT: Programming this item Blank does not disable phone routing. To disable reporting to this phone see Routing.
Programming Instructions
D5200 programming
1) Receive copy of 9000main
2) Enter group (PANEL WIDE PARAMETERS)
3) Enter group (Phone)
4) Make entry of Central Station phone number
*Must press ENTER for each prompt entry.
Part numbers D7212, D7412, D9112, D9124, D9412, D7412G, D9124G, D9412G, D7412GV2, D9124GV2, D9412GV2, D7412GV3, D9412GV3, D7412GV4, D9412GV4,