Issue
How can you move to a different Area using COMMAND 50?
Solution
To Move to an Area use following steps:
With this function you can perform tasks in an area other than the one you’re in without having to physically go to that area. Your access to other areas is limited by the scope of the command center and your authority level. For example, if your passcode gives you authority to all 8 areas, but the command center you’re working with is limited in scope to areas 1 and 2, then you will only be able to move to either area 1 or area 2. Upon moving to another area, the range of tasks you may perform depends upon the command center you’re working with. Once you’ve performed a task (such as Turning the Area On), the command center reverts back to its programmed area after 10 seconds. Thus only one task can be performed in another area at a time.
- Ensure that your command center is at idle text.
- Press the COMMAND bar. The display shows SYSTEM COMMAND.
- Press the 5 key, followed by the 0 key. The display shows ENTER AREA. Enter the area number you wish to move to. Press ENT.
- AREA X MOVE displays briefly, and then the text of the area you’ve moved to is displayed. You are now able to perform tasks in this area. The number of areas to which you can move will be limited by the scope of the command center. If you try to move to an area for which the command center does not have scope, NO AUTHORITY is displayed.
- When you have completed all tasks in the area you’ve moved to, simply allow the command center to time-out and revert to the area from which you started or enter the Move to Area function again.
Part numbers D7212B, D9112B, D7212B1, D9112B1, D7212, D7412, D9112, D9124, D9412, D7212G, D7412G, D7412G, D9124G, D9412G, D7212GV2, D7412GV2, D7412GV2, D9124GV2, D9412GV2, D7212GV3, D7412GV3,D7412GV3, D9412GV3, D7212GV4, D7412GV4, D7412GV4, D9412GV4, B8512G, B9512G
