The Alarm Bell sound during a Remote Arm or Disarm is configured with the Remote Warning setting.
Remote Warning
Default: No
Selections: Yes or No
This parameter pulses the alarm bell once (2-sec ON, then OFF) when the assigned area is remotely armed, and twice (2-sec ON, 2-sec OFF, 2-sec ON, then OFF) when the area is remotely disarmed. This parameter also applies to keyswitch arming and disarming.
Important:
- To comply with SIA CP-01 False Alarm Reduction, set this parameter to Yes. See SIA CP-01 Verification for more information.
- When upgrading a non-GV4 control panel account to a GV4 control panel account, RPS forces the default to No.
Parameter Options:
- Yes: The system uses the alarm bell output to annunciate the arming and disarming of an area through remote software, or a remote arming device (keyswitch or keyfob).
- No: No remote warning occurs to annunciate the arming or disarming of an area through remote software, or a remote arming device (keyswitch or keyfob).
Parameter Location:
- GV2 and GV3 8.00 thru 8.09 Panels: GV2AUX> Misc and Remote Warning.
- GV3 8.10 and Higher and GV4 Panels: AUXPARM> Misc – and Remote Warning.
- GV4 Version 1.x: AUXPARM > Misc and Remote Warning.
- GV4 Version 2+ and New G Series: Panel Wide Parameters > Miscellaneous and Remote Warning.