To use a shared area in conjunction with two associate areas is recommended that two Keypads be used, located in the associate areas. In total three areas are used. Area 1 is a tenant space, area 2 is also a tenant space but has a different tenant. Area 3 is an area shared by both tenants. Programming the panel to do this go to you will follow steps below
AREA WIDE PARAMETERS
AREA PARAMETERS
AREA 1
AREA ON “YES”
AREA TYPE “ASSOCIATE”
AREA 2
AREA ON “YES”
AREA TYPE “ASSOCIATE”
AREA 3
AREA ON “YES”
AREA TYPE “SHARED”
COMMAND CENTERS
COMMAND CENTER ASSIGNMENTS
CC ADRESS # 1
AREA ASSIGNED “1”
SCOPE “CUSTOM”
AREAS IN SCOPE
AREA 1 “YES”
AREA 3 “YES”
CC ADDRESS # 2
AREA ASSIGNED “2”
SCOPE “CUSTOM”
AREAS IN SCOPE
AREA 2 “YES”
AREA 3 “YES”
PASSCODE WORKSHEET
USER # X (Select the user number)
PASSCODE “XXXX” (Passcode desired)
A1 AUTH “X” (Authority Level desired)
A2 AUTH “X” (Authority Level desired)
** Note** Do not assign a authority level to area 3 as this is the shared area and a shared area will not arm as a shared area if it has a authority level assigned to it. The sequence of events are as follows, when arming and the last of the associate area completes its exit delay the shared area starts it exit delay and at the end of its exit delay becomes armed. When disarming the first associate area will also disarm the shared area.