About CPrince

Issue - If the Analog panel has multiple loop cards and each device on each loop card can be address from 1 to 126, how does the D9068 report this points to Central Station? The D9068 DACT reports the point addresses as follows: Loop 1 Addresses 1 -126 report as Points 1 to 126 . Loop 2 Addresses 1 -126 report as Points 201 to 326 Loop 3 Addresses 1 -126 reports as Points 401 to 526 Loop 4 Addresses 1 -126 report as Points 601 to 726 Loop 5 Addresses 1 -126 report as Points 801 to 926 ... View more

The sound base address range is Addresses 128 to 254. The Address of the base is 127 plus the address of the head installed in the base.   Example: A Smoke Head Adresssed as 100 - plus 127 - will make the Sounder Base Address 227.  (100 + 127 = 227)     SCL 1 Address 1 thru 127 Smokes head making the bases Address 128 - 254 SCL 2 Address 1 thru 127 Smokes head making the bases Address 128 - 254   ... View more

Technical Bulletin TBF_11-05-09-01_FPD-7024_Issues ... View more

Issue Using the D7038 NAC Output as Switched Aux Power for the D125B. When I switch the power from the D7412G Relay (CMD 47), the input of the D7038 the power drops out and the Yellow Short LED lights and stays lit until I open the power loop to the D125B. Solution On the D7038, place DIP switch 1 to the OFF position. To activate a new switch settings, remove the AC and battery power from the D7038. Wait for 45 Seconds and restore power, now the new switch settings are active on the D7038. This should clear the Yellow Short LED. ... View more

Question - How can the NAC's of the D7038 panel have an output @ 2.5 amps when the panel only has 6 amps of total NAC power? Answer - You have a total of 6 amps output maximum,  you can drive any one NAC is 2.5 amps. If you drive NAC 1 at 2.5 amps, you only have 3.5 amps left to operate devices on the remaining 3 NAC circuits. ... View more