How to program RPS remote connection to the FPD-7024 via Cellular or Ethernet?

[#1]

Required programming for RPS remote connection to the FPD-7024 via Cellular or Ethernet.

1. Press 0 Enter 9876 to enter programming
2. Press 6 Program Accounts
3. Press 7 Alternate Communication – Select (0) Network *(See note below)
4. Press * / Back key once
5. Press 4 Ring Count to set it to (02) Press #
6. Press (* / BACK) key once – The display should read Program Modes on the top line
7. Next Enable Remote Programming - Press (3) Program System
8. Press (7) Remote Program
9. Press (1) Enable
10. Press (* / BACK) key once
11. Update the Option Buss - Press (3) Program System
12. Press (4) Option Buss
13. Press (1) Update Buss –

The keypad will display “Updating . . .  TOT BUS DEVS: XX”. XX is the total number of devices on the Option bus. If it displays (00) check wiring and addressing of each device on the Option bus. Each device needs to have its own unique address.  Repeat the steps above until all the devices are learned to the Option bus of the panel.\Press (* / BACK) key 3 Times to exit programming

14   Press (* / BACK) key 3 Times to exit programming

Note: RPS Connects to the Cellular or Ethernet device addressed as 250 only, it will never connect to a device addressed 134.