COMMAND 45 is used to adjust the time display on your Alpha II Command Center. When you enter COMMAND 4 the Alpha clock is shown in the display momentarily. By entering COMMAND 45, the clock is displayed and may be adjusted with the Alpha II keypad. IMPORTANT: The time should be checked and adjusted at least once a month to insure accuracy.
24-Hour clock settings
1:00pm = 13:00 5:00pm = 17:00 9:00pm = 21:00
2:00pm = 14:00 6:00pm = 18:00 10:00pm = 22:00
3:00pm = 15:00 7:00pm = 19:00 11:00pm = 23:00
4:00pm = 16:00 8:00pm = 20:00 12:01am = 00:01
To use COMMAND 45:
1. Ensure that the security system is disarmed.
2. Press the COMMAND bar. The display should show SYSTEM COMMAND, press 4, 5.
3. Press and release the 4 key, then press and release the 5 key. The display should show SET TIME=(time disply). To set a new time display, simply enter the desired time with the number keys on the Alpha II keypad. (Remember, the clock is set in military time standards, also known as the 24-hour clock. Enter four digits for a complete time setting.) The new time scrolls into the display from right to left, replacing the old display.
For example, to set a time of 1:15 a.m. you would enter the following: Press the 0 + 1 + 1 + 5 keys. The display shows SET TIME= 01:15.
4. When the display is correct, press the COMMAND bar to enter the time and exit from this mode. If the COMMAND bar is not pressed, the new time will not be entered and the Alpha II will revert back to the original time displayed. If no keys are pressed for 20 seconds, the Alpha II automatically exits from this mode.
Part numbers D8112, D8112A, D8112E, D8112E1, D8112G, D8112G1, D8112G2, D1252, D1252A
