NO RF DEVICES TO ADD may display if a previously working RF point was removed from the panel program but not from the receiver. RF points should always first be removed from the receiver using the RF Programming Menu. After removing the point from the wireless receiver the point can be turned off in the panel program.
The NO RF DEVICES TO ADD response occurs because the point number to be added to the receiver is already occupied by the previously programmed point.
Correct the problem by using the RF Programming Menu and select 3; Remove a Point. Next, continue by adding the new transmitter.
When adding wireless transmitters into the panel:
1. Add the point code for the wireless point into the panel program.
a. Wireless points use a point code using a 7 or 8 in the 4th digit, which indicates the expansion device address. Wireless receivers must be addressed to 7 or 8.
2. Add the transmitter to the panel using the RF Programming Menu.
D2212, D2412, D2812, D208RF, D216RF, D222, D223
