Step-by-step guide
Note the sticker on the front of the B450 which indicates switch positions for selecting an SDI2, SDI or Option Bus address (see figure 1).
Figure 1 Sticker with address configurations
B8512G, B9512G and B-Series types:
- The B450 is not required when the cellular communicator will be installed in the Mod-1 (lower) plug-in slot.
- Use the B450 in applications where signal strength is weak at the panel location. Install the B450 in a remote location with stronger signal strength and connect to SDI2. Follow the instructions below for GV4 panel types connecting to SDI2.
GV4 Panel Types:
- Only 1 network communicator is allowed on a single address. Use address 1 or 2 as needed to avoid conflicting with another network communicator on the same address.
- Connections with Remote Programming Software are available on either address 1 or 2.
- Only 1 network communicator is allowed on a single address. Use address 88 or 92 as needed to avoid conflicting with another network communicator on the same address.
- When used as sole communicator or as back-up communicator to Phone line, use address 4 for SDI address 88.
- When used as back-up communicator to Ethernet (B426) use address 5 for SDI address 92, unless the B450 will be used for RPS connections (see note 4 below).
- Note that SDI address 88 is required for connecting to Remote Programming Software (Ethernet is preferred when allowed).
GV2 v7.06+ Panel Types (SDI only):
- Use address 4 for SDI address 88.