About CPrince

 Option Bus NAC Outputs (FPP-RNAC-8A-4C) will never be in sync with the NAC Output of the panel (FPA-1000, FPA-1000-UL, FPA-1000-V2, or FPD-7024). OPtions are: 1.) Add another FPP-RNAC-8A-4C to the option bus. (The panel can support up to 4 FPP-RANC-8A-4C 's on the option bus). 2.) Use either NAC 1 or NAC 2 of the FACP to the input 1 of the FPP-RNAC-8A-4C out of input on to the AV's on the loop. Set Bank 1 Dipswitches (S1) all Off - (Follower). Bank 2 Dipswitches (S2) set Dipswitch 0 to On, Dipswitches 1 and 2 set the AC fail Delay. Set Dipswitches 3, 4, 5, and 6 to Off. *Note: In this cinfiguration the Trouble contact of the FPP-RNAC-8A-4C need to be monitored by the FACP. S2 Dipswitch option for AC Fail Delay Dipswitches 1 2 No Delay Off Off 1 Hour Delay Off On 3 Hour Delay On Off 6 Hour Delay On On ... View more

Replacement part for the D328 and D328A Relay Module for the following panels, D8024, D9024, D10024 and D10024A  is obsolete with no replacement availible for the older Radionics / Morley panels. You may need to upgrade the fire system if the output is required. The replacement for the D328A on a FPA-1000, FPA-1000-UL or FPA-1000-V2 is one of the following: FLM-325-2R4-2A, FLM-325-2R4-2AI, FLM-325-RR4-8A or FLM-325-2R4-8AI. ... View more

The central station is diplaying  the account online in the D6200 software. While the FPD-7024 keypad displays IP Path Fail and is reporting over the phone line.   To correct this -  Set the Time Sync option to 0 in the receivers network account database using the D6200 Software.    If Time Sycn is set to 1, the receiver falsely dispalys the account's status as online.   ... View more

In the lower left corner of the panel mother board there is a contrast adjustment POT near Relay 1. The POT is labeled as Contrast.   ... View more

To diagnose why the System Trouble LED is lit on the DACT Dialer. 1.) Connect the programming keypad (FMR-DACT-KEYPAD, D7033, or DS9447) to the dialer using the 5 pin harness. 2.) Press 1 Status - This will list all the troubles on the DACT.  Trouble Keypad - the Keypad is connected to the DACT - (you should see this trouble only, all other need to be corrected) Trouble Phone 1 Trouble Phone 2 Trouble with one of the points Trouble Progamming - This is caused by not programmed one or more of the following prompts: Program Accounts Account #1: Account #2: Phone Numbers Phone #1: ????????? Phone #2: ????????? Phone Control Phone #1 Format: Phone #2 Format: An Account number, phone number and format needs to be entered in each field. ... View more