About David

The 4412 and the 6412 swinger shunt is set to 1 by default. This feature allows the automatic bypass of points. If the swinger bypass is selected yes in the point index that is assigned to the point, and the point goes into alarm or trouble more times than the swinger count is set at in one arming cycle,  when the counter reaches 0 in 1 arming period, the alarm output and reporting can be disabled. Example. If I set the swinger count to 1 and there is one alarm in a single arming period, the counter will reach 0 and the point if programmed can be bypassed. The counter is reset every time the system is armed and disarmed. The actual counter can be changed in programming. To change the programming for the alarm output swinger, from keypad programming: 1. nibble 1029 default is 1, 0=disabled and can be 1-15      a. to access this nibble, press 1029 then the command key, enter the value you wish to change it to and press the * key. To change the programming for the point reports swinger, from keypad programming: 2. nibble 1030 default is 1, 0= disabled and can be 1-15.      a. to access this nibble, press 1030 then the command key, enter the value you wish to change it to and press the * key. Exit programming and retest the system to verify the changes took effect. ... View more

Enter Date & Time using the B92x Keypad: Press Menu + 5 (settings menu). Press 2 (date/time changes). Press 1 (time change)]. Enter passcode, then enter the date (MM/DD/YY) and press Enter. Press 2 (time change). Enter time in 12-hour format (HH:MM). Select Enter for 'am' or press next for 'pm'. Press Enter to save. Display the Current Date and Time: Press Menu + 5 (settings menu). Press 2 (date/time changes). Press 3 (show date time). Enter passcode, press Enter to select Show Time=On.   Enter Date & Time using the D1255 Keypad: Press [CMD] + [45] and enter a valid passcode when required.  The keypad displays ENT TIME. Enter the current hour and minute in 12 hour format.  The keypad displays AM ? Press Enter if the current time is AM, press Next and Enter if the current time is PM.  The keypad displays DATE. Enter the date (MM/DD/YY) and press Enter.  The keypad displays the current date and time. Display the Current Date and Time: Press [CMD] + [49] and enter a valid passcode when required.  The keypad displays Bright Display. Press Next, the keypad displays Dim Display. Press Next, the keypad displays Time Display.  Press Enter and the current data and time displays.  ... View more

 Below is a diagram of the D636A keypad which displays locations for the Serial Data connector, Protective Zones connector, Display Adjustment and etc. ... View more

The keypad will display ‘Command Disabled’ when the Menu key is pressed for one of the following reasons. If the menu item # 1 in the function list is set with a function 0 and marked yes for any Command Center. If all of the Functions for the Command Center are selected as No (disabled). To prevent the keypad from displaying ‘Command Disabled’ after selecting Menu; Select a non-zero value for the Function # of Menu Item 1. Ensure that at least one of the Menu Items intended for use are set as Yes. ... View more

Under Output Parameters and Output Configuration, set the Function as 1,15 for the Trapazoid Key, or 2,0 for the Rising Sun key.  The selected output will activate when the associated key is pressed.   In the below example, Output 1 will activate when the Trapazoid key is pressed and Output 2 will activate when the Rising Sun key is pressed.   ... View more