About David

When Command 7 or Command 9 are enabled in programming, specified points may show missing depending on the panel type. These points serve dual purposes; Command 7 and Command 9 and  also for supervising the data expansion bus.  When these points display missing in View Point Status there will be no impact on panel operation and no service is required.  The 'missing' response will only display while using 'View Point Status'. D9412G and D9412GV2: Points 128 and 248. D9112B: Points 72 and 136. D7212B: Point 72.   ... View more

When the Passcode Enter Function is set to Cycle Output (or Relay), and a user enters their passcode and presses [Enter], the Enter Key Output (or Relay) activates for 10 seconds. Two events are added to the panel log: Output ### Set with User ID and, Output ### Reset without User ID. When using enter key relay, the command center cannot be used for any other function that requires an enter key. ... View more

The D1260 has eprom chip rev 1.00 and needs to be upgraded to 1.04 or higher. Order the upgrade EEProm part number:  R19-D1260-0104 ... View more

The maximum distance for the DS7091 from the DS7090 panel is 500 feet. ... View more

In programming at address configuration, select Point Expander for the device type at the chosen address. Program the panel with a point code for each protective point. The point codes determine how each point responds to faults. Remember to use the correct device address (digit 4 of the point code) for each point you are programming. ... View more