About David

Locate address Address 1265 and set as 2 to enableground fault. Address 1265 is defaulted at 0. Set as 2 to enable ground fault display. Set as 1 to enable ground fault display and AC fail trouble tone. ... View more

Locate Program Address 47 and enter 1# to return programming to factory default.   Address 47 then enter 1 # to default the panel. ... View more

D7212G/D7412G/D9412G Control Panels using Address 88: RADXAUX1 -> SDI RPS/Enhanced Co -> D9133 Supervision -> Yes D7212GV2/D7412GV2/D9412GV2 Control Panels using Address 88: GV2AUX -> SDI RPS/Enhanced Co -> SDI Device Address 88 Supervision -> Yes D7212G/D7412G/D9412G Control Panels using Address 80: RADXAUX1 -> SDI Automation -> D9133 Supervision -> Yes D7212GV2/D7412GV2/D9412GV2 Control Panels using Address 80: GV2AUX -> SDI Automation -> SDI Device Address 80 Supervision -> Yes Notes Please note the difference between a DX4020 configured with address 80 and a DX4020 configured with address 88. Address 88 allows for DX4020 supervision for applications such as network communications to a D6600 Central Station Receiver, or RPS over a network. Address 80 allows for DX4020 supervision when a DX4020 has been setup for network applications such as home automation or access software integration.     When a DX4020 has been supervised on the SDI bus, the following system trouble will be displayed on the command center in the event of a SDI communication problem with the DX4020, 'SERVC SDI #' (Where SDI # is the address of the DX4020). ... View more

The D5200 programmer returns the error: Ram Card Protected when attempting to format, update or save files. Slide write protection switch to the non-write protected side to allow writing to disk. ... View more

The Auto Protection Mode in expert programming, item 132 has been changed from the default setting of 1 to 0. Set Item 132 in Expert Programming to 1. This is comparable to the Arm No Exit feature on the GV2 panels. ... View more