About CPrince

Use the program menu tree shown below to program D9068 using the FMR-DACT-KEYPAD or D7033 Programming Keypad.     ... View more

Question - How do I stop the FLM‑325‑CZM4 Conventional Zone Module from always reading open on the FPA-1000-UL Display? Answer - The FLM‑325‑CZM4 Conventional Zone Module requires a 24 VDC  filtered power non-resetting. ... View more

Issue - Panel display's Open SLC 1 or Open SLC Solution - When the SLC loops are wired Class A, an open on the positve (S+) loop wiring will cause the the panel to display "Open SLC1 or Open SLC 2". *Note - This is a latching fault condition and will not clear until RESET is pressed.** To find an intermittent open, program the SLC to be a SINGLE CLASS B LOOP and remove the wires from the return loop S2+ and SC2-. When the fault occurs again all the points beyond the break will report as missing. ... View more

Question- What happens if a point is programmed / configured as a "GENERIC" point type? Answer - "GENERIC" Point Type Operation Open Condition - Will activate trouble tone, the panel keypad will display trouble and a trouble report is sent to Central Station. Short Condition - The alarm report is sent to Central Station, the panel keypad will not display or activate sounders for this type of alarm.  The point works as a silent alarm point when programmed / configured as GENERIC point type. ... View more

Issue - The AHJ (Authority Having Jurisdiction) is requiring an instant AC Fail be displayed at the panel and the AC Fail relay to change states. Solution - Set the AC Fail Time to (00) for an instant AC Fail response (No Delay). ... View more