About David

Install a D136 into the Relay B slot (ALT Alarm) or Relay C (SW AUX) with 3 pins in the top of the socket, 2 pins in the bottom of the socket. You can install the D136  either to the right or left side of the socket. GV2 and newer control panels come with D136 relays already installed on the main board. ... View more

SERVC COMM FAIL is the response on D7212B, D7212B1 or D9112B command centers after 10 unsuccessful attempts to communicate to the receiver. It is a similar response to newer 7000/9000 (G and GV2) series panels that return COMM FAIL RTE # after 10 unsuccessful communication attempts. Notes For more information see: 74-06913-000-B D7212B Operation & Installation manual pg. 28 74-06144-000-C D9112B Operation & Installation manual pg. 28 ... View more

Access to all panels can be locked by changing the panel lock code.  Use Remote Programming Software to change the Data Lock Code or Lock-Code.  The D5200 can also be used to change the panel lock code on legacy panel types. The RPS Passcode or RAM Passcode is required for access to Remote Progarmming Software. Change the RPS Passcode (or RAM Passcode) using either RPS or the D5200.  Yes, The D5200 handheld programmer needs to match a Data Lock Code to access programming. RPS (Remote Programming Software) needs to match a RAM Passcode and the Data Lock Code to access programming. The Data Lock Code is a 5 digit code that is entered from either the D5200 or RPS (default 12345). The RAM Passcode Code is a 6 digit code that is entered from either the D5200 or RPS (default 999999). ... View more

 What does the Remote Reset command communicate using Modem IIIa2 format when connected to RPS via a network connection? 7000/9000 and G-Series Control Panels The 7000/9000 and G-Series Control Panels send a Reboot event up to version 7.0 when using the Reset Panel command when disconnecting with RPS from the network. Automation sometimes reads the command as a local reset instead of a remote reset (i.e., using a reset pin  instead of an RPS reboot). The event codes are: SIA Event Code 'RR' 6500 Event Code 'D14' GV2-Series Control Panels GV2-Series Control Panels send a Remote Reset event. This event is the correct event for a panel remotely reset via RPS. The event codes are: SIA Event Code 'RN' 6500 Event Code 'D11' ... View more

Question Why is the control panel arming Partition 2 when I enter Command 3? Answer The D4412 and D6412 control panels do not use the same command menu that the D4112, D6112, D8112, and D7000/D9000 control panels use. CMD 3 performs a Part 2 Arm instead of a perimeter delay. Use the Part On button for a perimeter delay arm. Part 2 Arm allows a user to customize points to arm. Furthermore, if no points are assigned to Part Arm 2 by using CMD 65, the control panel will not arm any protection zones. By default, none of the protection points are assigned to Part Arm 2. ... View more