How can you Test Onboard Points FPD-7024, DS9400 Series & D7024 Series Fire Panels

[#1]

Issue

How is an on-board point on a FPD-7024, D7024 or DS9400 Series Fire Alarm Control Panel (FACP) tested?

Solution

Read Zone Input Levels follow the steps below

Use the following steps to test an on-board point on the FPD-7024, D7024 or DS9400 Series FACP:

1. Press [TEST] on the FACP's built-in keypad or the Remote LCD Remote Keypad. 
2. Press [7] to select "Test Inputs."
3. Enter the point number (1 to 8 )to test followed by [#/Cmd].

This test shows the loop current of a selected on-board point:

• Normal loop: 11 to 15 mA
• Dirty Smoke: 17 - 23 mA - The Loop Resistent is Higher than 2.2K Ohms
• Loop in Alarm: over 25 mA
• Loop in Trouble: less than 6 mA

Part numbers FPD-7024, D7024, DS9400, DS9400I, DS9400M