About David

By default, the Installer Passcode Override option is Enabled. If enabled, short the two solder pads to the lower right of the System Test button when prompted for the installer code. This will allow access to the programming mode. To disable Installer Passcode Override, set item 122 in Expert programming to 0. ... View more

Proper polarity must be observed when wiring the End of Line (EOL) resistor to an onboard point on a compatible control panel. The EOL resistor must be wired in series on the TRBL PT + terminal. The compatible control panels are listed as follows: Easy Series, D2212, D2212B, D2212BE, D2812, D4412, D6412, DS7220, DS7240. ... View more

 Connect smoke detectors to any supervised panel point. Using a suitable power supervision device according to manufacturers instructions, route power to smokes using a form C relay such as the Bosch D133 or D134, as follows: D2212 EXT1 to D133/D134 X1- D2212 Aux Power+ to D133/D134 X1+ D133/D134 Comm 1 to 4 wire smoke detector (-) D133/D134 N/C 1 to 4 wire smoke detector (+) Program 2212 handler as follows: Relay 1 Logic= Function 1 Only Function 1= Reset ... View more

During the exit delay, press Command and then the zone # you wish to selectively shunt. The point will now be bypassed. Make sure item 99 Shnt MA is a Yes in the program under 17. OMEGALARM ARMING STATION OPTIONS. ... View more

  Point expander zone trouble from the DS7101 or trouble on zone 13 or 14 will show up on on the keypad as Trouble Zone 15. ... View more