About David

Program the keyswitch point with the zone code A91##. If an onboard zone were used, enter A910A. Expanded points would use the address of the expandion device followed by the loop code. Keyswitch points always generate a trouble condition in the open condition while disarmed and an alarm condition when open in the armed state regardless of the setting of digit 3. Shorting the point from a normal condition toggles the armed state of the panel.   ... View more

At least one point in the panel is following a point index with 'Buzz on Fault' set to YES. When set to Yes, the command center will sound the trouble tone for any fault condition and CHECK DEVICE will display until the point is restored to normal. If Buzz on Fault is not desired, either modify the Buzz on Fault setting to No or use a different point index to the point with the parameter set to No.  ... View more

The Enter Key Relay parameter in the Command Center Assignments area of programming has a non-0 entry.  This parameter is for entering a relay or output that will momentarily activate for 10 seconds when a user enters a valid passcode and presses [ENTER]. Change this entry to 0 to resume normal operation of the keypad. ... View more

Press [#] + [42] and a valid passcode.  The keypad displays call for service. Press the 0 key when the call for service message displays.   The error message will display on the keypad. ... View more

Although LED keypads have no ability to select an address, the panel program must have an LED keypad selected under 'Address Configuration' when one will be connected. Use one address for all LED keypads for the address configuration of the panel programming. ... View more