About David

Perform the following procedure to disable reporting on a D4412 or D6412: At the control panel, lock down the installers switch. From the keypad, press Cmd 41 and then enter the installer's passcode. Press 8 for keypad programming. Press 0221 Cmd. Press 0 and then the star key (*). Press and hold the Cmd key to exit programming. Unlock the installer's switch. In RPS, go to Global Reporting Options and then set Enable Reporting to No. ... View more

The FA113 has not been properly programmed into the D8125INV. Points 74 (194 on zonex 2) and 75 (195 on zonex 2) must both be learned into the D8125INV. The FA113 Keyfob has four buttons: ON, OFF, and two Alert (*) buttons. The ON button is used to arm the area point 74 or 194 (zonex 2) is assigned to and initiate the Master Arm Delay state. The OFF button is used to disarm the area to which the point is assigned.  The Point Index for Point 74 and 194 must be programmed as a Point Type 4, Point Response 2.  When both Alert buttons (stars) are pressed, the D8125INV sends a Short to the control panel for Point 75 or 195 (Zonex 2). Program the control panel accordingly so that the Point Response provides the appropriate response on short. Pt74 or 194 (zonex 2) must be learned as a new point. Point 75 or 195 (zonex 2) is leaned in as an existing point. When programmed incorrectly and both star keys are pressed, Servc RF Low Battery is generated on the panel command center. The FA113 is learned into the D8125INV using mode 4. For more details, see the D8125INV Operation and Installation guide 49690E pg22. ... View more

Issue   How do I transmit a test report? Solution Transmit Test Report Testing the communication link between your security system and the Central Station is an important part of maintaining high level of security for your property. The Command Center minimizes the time and trouble of testing by allowing you to send a special test signal just by pressing three keys. Arming the system is not necessary, however you should always call the Central Station before transmitting a test report. To use COMMAND 41: 1. Ensure that your security system is disarmed. 2. Press the COMMAND bar. The Command Mode indicator light comes on. 3. Press the 4 key, and then press the 1 key. 4. After the report is received at the Central Station, the Command Center will emit a beep tone for two seconds. This is to confirm that the test signal was properly transmitted and received. ... View more

 When the control panel has been armed for less than 2 minutes and an alarm is generated, an Alarm Recent Closing Report is sent along with the user number.  The monitoring station may not interpret the Alarm Recent Closing Report report as a standard Alarm report and therefore claim they never got the alarm report.  If than 2 minutes are allowed to pass after arming the panel and generating an alarm, a standard alarm report is sent which should be intpreted by the monitoring station as an alarm. There are no configuration settings to modify this operation. ... View more

Canned smoke must be used to test the RF280THS and generate a panel alarm. After the RF280THS test button is pressed, View Point Status will reflect the point state as changed however a panel alarm will not be generated. Simulate an alarm following the instructions for an Underwrites Laboratories, Inc. (UL) Listed aerosol smoke detector tester, such as the Home Safeguard Industries' 25S. ... View more