About CPrince

Issue What is the Bosch part number for the Inovonics FA206DS wireless motion detector?   Solution   The Bosch part number for the FA206DS would be the DS775RF and is used with the Inovonics FA400 receiver and the Bosch D8125INV wireless interface for Bosch D7412G/D9412G control panels. ... View more

Issue All zones on master zone 800 show trouble condition.   Solution   If programming panel for horizontal mode, zone 808 is not used. Text for zone 808 must be disabled, and if using a D8128B module dipswitch for zone 808, should be turned to the off position on module.   Part numbers D8112, D8112A, D8112E, D8112E1, D8112G, D8112G1, D8112G2 ... View more

Issue Does Bosch make a mounting bracket for the DS775I?   Solution   Yes: B335 = Low profile mount bracket B328 = Gimbal mount bracket B338 = Ceiling mount bracket ... View more

Issue What is the proper alignment procedure for the DS455Q? Solution  Alignment by LED Apply power to the system. Use the supplied interruption sheets to cover the lower optical modules of the transmitter and the receiver. Look into the upper scope of the transmitter 10 cm (3.9 in.) to 15 cm (5.9 in.) from the optical module. Use the turntable to adjust the horizontal angle. Use the horizontal and vertical adjustment screws to locate the receiver in the center of the viewing area. Look at the Level Meter on the receiver to proceed with fine tuning.  Use a screwdriver to adjust the angle of the upper optical module. As more beam energy is received, each LED status follows this sequence: ON_Flashes quickly_Flashes slowly=>OFF Continue fine tuning until all LEDs turn off. Remove the interruption sheets from the lower optical modules and cover the upper optical modules of the transmitter and the receiver. Repeat the alignment process for the lower optical modules. When all LEDs turn off, the alignment is complete. Remove the interruption sheets from the optical modules. Alignment Using a Voltmeter Apply power to the system. Use the supplied interruption sheets to cover the lower optical modules of the transmitter and the receiver. Insert the voltmeter leads into the alignment check terminals. Set the voltmeter to 10 volts VDC. Use a screwdriver and adjust the upper optical modules to obtain the maximum voltage. In an ideal environment, the voltage is 3.0 VDC or above. Remove the interruption sheets from the lower optical modules and cover the upper optical modules of the transmitter and the receiver. Repeat the alignment process for the lower optical modules. Make sure to remove the interruption sheets and close the covers when alignment is complete. ... View more

Issue What does the Green Status light indicate? Solution Green Status Light: OFF = One or more zones are violated, or the control is armed Flashing = Exit delay period is in progress ON = All zones are secure or bypassed ... View more