About CPrince

In the lower left corner of the panel mother board there is a contrast adjustment POT near Relay 1. The POT is labeled as Contrast.   ... View more

Diagnose why the System Trouble LED is lit on the D9068 DACT Dialer. Connect the programming keypad (FMR-DACT-KEYPAD, D7033, or DS9447) to the dialer using the 5 pin harness. Press 1 Status - Each of the existing DACT troubles will display. Trouble Keypad - the Keypad is connected to the DACT. This is normal while the programming keypad is connected. There should be no other other troubles displayed. Trouble Phone 1 - a trouble exists on phone line 1. Trouble Phone 2 - a trouble exists on phone line 2. Trouble with one of the points. Trouble Progamming - This will display when one or more of the below items is missing. Program Accounts Account #1: Account #2: Phone Numbers Phone #1: ????????? Phone #2: ????????? Phone Control Phone #1 Format: Phone #2 Format: ... View more

Step-by-step guide   To reset the the FPA-1000 press reset button on the bottom left of the panel next to Relay 1. You can also reset the panel by cycling power. To cycle power remove both AC and Battery power  wait 30 seconds and  reapply AC and Battery  power to the panel.   ... View more

The D7050 Photoelectric Smoke and  the D7050TH Photoelectric Smoke with Fixed 135 Heat Sensor will on the follow panels. D7024 with a D7039 MUX Card FPD-7024 with a D7039 MUX Card DS9400i with a DS9431 MUX Card DS9400M with a DS9431 MUX Card D9412G with a D8125MUX Interface Card  D7412G with a D8125MUX Interface Card  D9412GV2 with a D8125MUX Interface Card  D7412GV2 with a D8125MUX Interface Card  D7412GV3 with a D8125MUX Interface Card  D9412GV3 with a D8125MUX Interface Card  D7412GV4 with a D8125MUX Interface Card D9412GV4 with a D8125MUX Interface Card B8512G with a D8125MUX & B600 Interface Card B9512G with a D8125MUX & B600 Interface Card DS7400Xi (Ver 3+) with a DS7430 or DS7436 Interface Card  DS7400Xi (Ver 4+) with a DS7430 or DS7436 Interface Card ... View more

Unfortunately, there is no available replacement printer for the old Morley panels. Additionally, there are no printer interfaces available to connect a standard printer to the panel. The Fire-5 software was used for programming these panels, however, it did not provide a function to capture or print the panel log.   If printing were required, the only work around would be to replace this panel with the FPA-1000-UL Compact Fire Panel. ... View more