Bosch Building Technologies

    Showing results for 
    Search instead for 
    Did you mean: 

    Security: Access Control

    Sort by:
    ‎03-07-2024 04:42 PM
    Once an elevator door model is used on an AMC controller in AMS, no other door models can be added to that controller.
    View full article
    100% helpful (3/3)
    ‎07-22-2022 08:15 AM
    Check this article and find out if it is possible to connect AMC IP controllers together via RS485
    View full article
    ‎04-26-2022 08:50 AM
    When upgrading from a version 2.xx escort to a version 3.xx, one of the steps is to backup and restore a transponder.xml file.
    View full article
    ‎04-11-2022 02:06 PM
    This article contains the part numbers for the Security Escort licenses 
    View full article
    ‎03-30-2022 05:06 PM
    This article provides you with the response to the question: "if I have a newer AEC firmware version, "2.1.9.x", can I downgrade it to"
    View full article
    ‎03-30-2022 04:13 PM
    You would need to upload firmware FIRST and then you can got to
    View full article
    ‎03-18-2022 02:13 PM
    When adding doors in AMS, the software will by default, assign each door strike relay based on the first available unused output on the controller.
    View full article
    100% helpful (1/1)
    ‎03-18-2022 02:03 PM
    See the 3 different part numbers of a Security Escort USB dongle, depending on what license you currently have or want to obtain.
    View full article
    ‎03-08-2022 04:48 PM
    This article contains the network ports that the Access Easy Controller (AEC) and Access Easy Master Controller (AEMC) use to communicate on the network.
    View full article
    ‎03-07-2022 02:13 PM
    This article presents what is the compatibility of the ARD-AYCE658 Reader with AEC 2.1.
    View full article
    ‎03-07-2022 01:58 PM
    This article explains what does a repeating low tone, high tone, and 1 sec pause mean on the AEC v. 2?
    View full article
    ‎03-07-2022 01:57 PM
    This article explains the message "Door already in use" from AECv2 when trying to delete a reader board
    View full article
    ‎02-28-2022 05:16 PM
    Reader Board 1 has three spare relays and each subsequent Reader Board has four spare relays.
    View full article
    ‎05-13-2021 08:38 AM
    Below is a image which gives an overview of the AMC power supply consumption requirements: Typical IClass readers consume .78VA average and slightly over 1VA at maximum. The ARD-FPBEW2-H2 Bio Reader has an average of 7.2 VA average and almost 8VA maximum.
    View full article
    ‎05-11-2021 08:31 AM
    Question   What readers are currently supported with AMS   Answer   Below is the "current" list of readers that are supported with AMS. This may be subject to change as more readers are tested and approved.  
    View full article
    Top Contributors