Step-by-step guide
Steps to focusing a Box camera:
- Start by opening the Lens Wizard in the Installer Menu
- Set the Back Focus to the Center position
- By pressing Center Button
- When the Focus position is finished it will be centered at 500.
- Set the Zoom manually (Wide to Tele) to customize the image boundaries.
- Then focus the lens manually
- By physically adjusting the focus on the lens body.
- Adjust the manual lens focus as good as physically possible.
- Finally, press ‘Full Range’ to allow the camera to auto focus for the optimum image focus.
- The objective is to have the camera's focus position set near the Focus Position of 500 position.
- If the focus position is off center like the below image, the camera/lens could have problems focusing from edge to edge.
- To focus on a specific area
- Select the area by dragging the Rectangle to shade the specific area that you want to focus.
- Then press Local Range to focus on the specific area.