Can I display Camera Name & Number in BVMS Op. Client MG or HW monitor connected to the decoder?
The MG Camera Name and Number Setting (BVMS Configuration Client, under MG Camera Settings)was not designed for BVMSOperatorClient cameo, but in fact for the CPP-Enc type of decoder like VJD-3000.
These decoders supported an OSD command which allowed BVMS to write its logical number to the decoders monitor output and the position would depend on if it is in Fullscreen or Quad mode (exact xy position based on the complete visible screen).
The High-Performance Decoders do not support this feature. Therefore, for example, the camera number will not be displayed on HDMI Monitor connected to a VJD-7523.
This was mentioned in the RL from BVMS v5.5.5 till v10.1.1: