transparant data transmission at a Encoder VideoJet Multi 4000 or VIP-X16-XF-E stops / does not work any longer in case of a power outage and restart of the device.
when e.g. controlling a Bosch Autodome 7000 and PTZ via Transparent Data not working after reboot of the encoder, this is caused by an issue in the released firmware. It doesn't matter if it is Firmware 6.30.0047 or 6.30.0059. As a power outage should happen not too often the solution below is offered to fix this.
The solution is via a workaround using an ATSL script in the encoder to re-set the COM port baud-rate upon a reboot/restart of the encoder (which should in normal practice not happen to often).
Please add th following scritp to the Alarm Task Editor tab either via CM or Web interface.
There will be no furhter release or fix provided by BOSCH status of 2019-03-19 as the ATSL script resolves this.