About rlarkins

What restrictions are there on passwords in ReadykeyPro? Solution Password Standards When creating a strong password keep the following guidelines in mind: Passwords cannot be blank • Passwords cannot be the same as the user name (e.g. SA, SA) • Passwords cannot be Bosch keywords (e.g. multimedia, Bosch, Prokupets,Prokupet, basis, and password) • Although not required, your password should contain numbers, letters, andsymbols. Spaces are also acceptable. (e.g. august 18, 1967) • ReadykeyPRO passwords are not case-sensitive. • Database passwords conform to the rules of the specific database being used;SQL Server uses case insensitive passwords. • The maximum value for a strong password is 127 characters. The minimum value is 1. NOTE - These password restrictions were valid BEFORE rdkypro version 6.4. They more than likely have changed since then. ... View more

"Reader type” in software configuration is incorrect. If using the dual interface module, be sure to specify RDR2 in the settings for RDR1. If interface module is incorrect (dual configured as a single), you will need to delete the reader entirely and add it again as a new reader. Restarting Alarm Monitoring may be necessary to view the reader online. ... View more

1. TCP/IP Connection Errors – TCP/IP must be configured on all workstations running Alarm Monitoring. Use a static IP address, not DHCP. 2. The Access Control Driver (LS Communication Server) may not be running, or was started improperly. Close Alarm Monitoring and start driver either interactively via the Start Menu or through the SERVICES Control panel. 3. Workstation running Alarm Monitoring is not in the monitoring zone for the access panel. 4. Workstation name is incorrect in software configuration for access panel. ... View more

In "System Administration", click on "Monitoring" then select "Alarms". Click on the "Text" tab. Next click "Add". Under Name, give the note a specific name. Under Type select "Ack. Note. In the large window below, you can add your "special instructions." Then hit OK then close, next log out and back into "Sys Admin". When you "Ack" alarm you should now have the "Ack Notes" to choose from. ... View more

The SE2-304 has 3 main features, the lanyard switch, man down, and transmitter supervision. To enable these features:                 1) Remove the belt clip.                 2) Remove the retaining screw on the back of the transmitter.                 3) Pry the lower part of the front cover away from the rest of the enclosure.  With the cover removed all three rows of pins will be visible. With the alarm switch in the Up position. -To enable the lanyard alarm feature place the jumper on the top row of pins, covering both pins. -To enable the man-down feature cover the middle row of pins with the jumper. -To enable supervision place a jumper over the bottom row of pins. ... View more