Security: Access Control

Article describes how to default the IP address of an AEC 1.0.

Article explains how to backup an AEC 1 or AEMC1/Allplex master database.

How to connect to an AEC panel directly for a PC.

Possible solution for an erro message "invalid card format".

This describes what triggers the AEC common relay output.

Possible solution to transactions Not Displaying in AEC View Activity screen

This article will provide the workflow for adding an additional reader board to the primary RS-485 bus of an Access Easy Controller system.

These are steps to assist with troubleshooting the AEC 2.1 time drifting.

This article provides the solution when the computer cannot access the AEC2.1 if the Lantronix device is on the same subnet as the AEC2.1.

Most AEC firmware versions (2.1.7.10c V1 and earlier) are not compatible with Internet Explorer versions 8 and up.  This may prevent the Card Administration screen from displaying the cardholders. This is a workaround for that issue

How is the Duress Alarm event generated in the Access Easy Controller?

Can I assign an Exit Door function type as a device in the Criteria configuration so that I can trigger a relay for Door Forced Open or Door Held Open?