About David

Program Route Group 1: Set Primary as SDI; set Backup as Phone 1. Route Group 1: Turn on all needed reports and turn off Test Timer report for Route Group 1. Program Route Group 2: Set Primary as Phone 1; set Backup as No Device. Route Group 2: Turn on only Test Report. Set a SKED as Function (9) Timer Test. Leave Hourly and Deferred to NO. Set the Time for the Timer Test - (00:01 = 1 minute after midnight). Leave the Date Blank. Set Each day of the week you want the test sent to Yes. Leave all Holiday Promgramming Options at default. ... View more

Operation LED Descriptions   LED Status Function Flashing: 1/2 second on, 1/2 second off         The D8125MUX scans its programmed multiplex points and operates normally. OFF A module fault is indicated. ON The Multiplex Point Programmer is connected to the D8125MUX. Flash 2x-1x-2x-1x..., etc. D8125MUX EEPROM has been rest to factory default To reset the D8125MUX EEPROM: Connect the D5060 Programmer to the 4-pin Program Port on the D8125Mux.  The LED changes from 1/2 second flash to steady on. Place a shoring bar over the reset pins. The LED flash pattern changes from steady on to flash to 2x-1x-2x-1x indicating the default is complete. ... View more

Steps to program a receiver into the EN4204R Echo Stream stand-alone receiver. Open the receiver housing. Connect the power cabling. Set the frequency band. Press the Advance button to select the first transmitter point to program Press the Program button to begin programming the point. Use the Advance button to choose a supervision window; press Program to complete and advance to the output option. Use the Advance button to select the output number; press Program to complete and advance to the output type option. Use the Advance button to select the output type. If programming the EN4204 press Program to complete and advance to the switch type option; if programming the EN4204R, press Program to complete and skip to step 10. Use the Advance button to choose between normally open and normally closed; press Program to complete programming. If you wish to register a transmitter to the point you’ve just programmed, press the transmitter’s Reset button; otherwise, press Program to save programming changes without registering a transmitter. Press Advance to choose the next transmitter point to program. ... View more

After the first ring from the modem, press the key as noted below: B-Series, New G-Series and GV4 Version 2.x: Press Menu + 3 + 4 + 1 at the keypad. 7000/9000 series, G-GV4 version 1.x: Press [CMD] + [43] at the keypad. D6412/D4412: Press [CMD] + [43] at the keypad. 2000 Series Panels: Press 2+ Owner Code. D4112/D6112/D8112: Press [CMD] + [43] at the keypad. ... View more

This solution is to resolve the issue where previously programmed custom text does not display after replacing an LCD keypad. To replace an LCD keypad set at address 1 that has custom text: Obtain a copy of the panel program, using a D5200 Attach the new keypad to the panel Send the copied program back to the panel  If LED keypads and LCD keypads are on the same system, the LCD keypad must be at address 1 for this change to take into effect. D2212, D2412, D2812,Custom Text, D223,D222, Remote Programming Software, D5200 ... View more