My Network Recorder program will not open and gives an message saying " # defined active channels. Key allows for # channels." - why?
To get back into the Network Recorder you will have to delete a file and then reprogram the NR with the multicast addresses. This will reset the Network Recorder Multicast Table to factory defaults and will also enable you to run the program with a lower line Network Recorder key.
After completing these steps you will need to reprogram the Multicast addresses of your IP-223’s that you want it to record:
To reset the Multicast addresses in the Network Recorder, delete the file recordIP.telex located at C:\Program Files\Telex Communications\Telex Network Recorder\DataFiles\
Reboot the Network Recorder and now you should be able to program the NR with the multicast addresses and then the NR program will run.
© Copyright Bosch Security Systems
All rights reserved. Text, images, graphics, sound, animations and videos as well as the arrangement of the same in Bosch offline knowledgebase (help file) are protected by copyright and other intellectual property rights. The content of these offline knowledgebase may not be copied, disseminated, altered or made accessible to third parties for commercial purposes. Some Bosch web sites may also contain text, images, graphics, sound, animations and videos subject to third party copyrights.
This information is provided by Bosch Security Systems ''AS IS'' and without warranty of any kind, expressed or implied, including (but not limited to) any implied warranties of merchantability, fitness for any particular purpose or non-infringement. While the information provided in believed to be accurate, it may include errors or inaccuracies. Bosch Security Systems will not be liable for any damages of any kind arising from use of this tool, including, but not limited to, direct, indirect, incidental, punitive and consequential damages.
View full article