Fire

This article is a step by step guide about how to create panel container on map by using Macro-Area (point) on FMS.

This article answer to the question: " What is the maximum of simultaneous client connections supported on FSM?"

This article explains how you can reset the FPA-1000, FPA-1000-UL, and FPA-1000-V2 panels.

This article answer to the question: Is the usage of command and digital properties function supported -FSM?

Is the status displayed when Supervisory Usage type is selected in RPS - Bosch Fire Monitoring System?

This article explains is we can use Remote desktop to run or use the FSM client. When using remote desktop the error below will be shown when remote desktop is minimized and then maximized, the only option is to close the FSM client and start again.

This article presents causes and solution about different detector symbols displayed at different clients in FSM. 

This article answer to the question: "Can a fire alarm have the same sound as the one for a fault?"

This article explains step by step how to enable commands for operator (other than admin) in FSM

This article response to the question if there is an automatic time sync between FSM and panel?

This article provides a solution regarding the ringtone alarm which can be stopped in FSM. 

Have a look at this article and see how you can setup the FMS - OSD Logo

Follow this article and learn about the option which allows you to configure the color for each state & sensor in FSM

A modification of the sensor group icon is possible but requires a different file naming than for detectors

Library is offering 3 different sizes of detectors and can be customized. See this article and find out how you can customize Symbols (icons) - FSM

Live time event printing is supported. To enable it, add a xml file in program data folder with the name of the printer.

To silence all NAC's of one panel (FPA-5000/Avenar) from the map in FSM Step-by-step guide   Insert a sensor on the map of FSM Under sensor properties choose: General: Add symbol: FIRE_Panel_FPA_BG Settings: Driver Instance: the panel / compound where the FSM is belongs to Address-> e.g. Panel 1-10.1 ! Please pay attention: there are other “Panel” possibilities to choose. Please do not choose Panel 1-10 (Communication)! After inserting the settings click “ok” Then Apply At the map when you right click the panel symbol you will get the commands as shown below.   If there is a fire alarm, you can right click at the panel and then click at “silence on”. Please be sure, that then every NAC which is belonging to this panel is “silenced”. Additional: there is also a command "silence scope" which then has the effect, that the whole scope will be silenced.

This article presents step by step how to configure the “E-Mail Sender” function in FSM.

This article explain what should be done if new detectors are added to the system. 

This article answers the question:  What is the difference between "Actual status" and "Alarm status"?