Fire

In the controller history, you can see entry as detailed below, showing Detector -On- 14 , what does this indicate?

The following steps describe an efficient way to update the panel firmware in an AVENAR panel 4.x network via SD card, thus keeping downtime of the panels to a minimum. To further reduce downtime, it is recommended to network the panel nodes via ETH.

Thanks to the latest AI technology and deep learning methods, the newest generation of fire detection cameras AVIOTEC 8000i IR becomes the best, fastest and more robust option for applications where traditional detectors might find limitations.

In the event of flames and smoke, the camera's built-in intelligent algorithms analyze the scene in real time by concatenating and transforming the input data. Deep learning AI directly analyses the data and if a fire is confirmed, it triggers an alarm and sends a signal either to the fire panel or the Video Management System.

AVIOTEC 8000i IR achieves an average of 3x faster detection times compared to current Aspirating Smoke Detectors*.

Typical application areas: Industrial manufacturing; Transportation: airports & railways; Logistics and warehouses; Parking: eMobility

This article provides instructions for troubleshooting Ground Fault in the FPD-7024 or D7024

How to interpret DBL when displayed on the FPD-7024 or D7024.

The cause of the error is combination of group address and the text length of the group label as defined in RPS as shown in this article

This article describes how to capture the panel/ controller communication log when requested by Technical support.

Panel controller displays can become de-calibrated, e.g. upon initial power-up followed by unintentional contact with the display or inaccurately touching the crosshairs.  It becomes noticeable after the panel controller has re-booted and does not respond properly to touch.

This article contains the RCP+ CGI commands for AVIOTEC starlight 8000 that helps you to enable or disable the scene quality (bright or dark)

This article contains the RCP+ CGI command for AVIOTEC starlight 8000 that helps you to adjust the VCA darkness or brightness level

This article answer if the labels or texts automatically updated in FSM after change in RPS.  

Is it possible to use complex maps on the FSM client? Recommendation is not to use very complex maps, very complex maps (means big size DWG files) can be made “lighter” by reducing the number of vertex (e.g. remove texts in DWG file and make rather use of the FSM text feature)

This article is a step by step guide about how to create panel container on map by using Macro-Area (point) on FMS.

This article answer to the question: " What is the maximum of simultaneous client connections supported on FSM?"

This article explains how you can reset the FPA-1000, FPA-1000-UL, and FPA-1000-V2 panels.

This article answer to the question: Is the usage of command and digital properties function supported -FSM?

Is the status displayed when Supervisory Usage type is selected in RPS - Bosch Fire Monitoring System?