Fire

Uses for the  D298M over a D298S or D278S popited base? D278S 12 volt popit base. D298S 24 volt popit base. The D298M is a 24 volt popit base that provides connections for up to 19 supervised circuits two-wire slave detectors (D287 2-Wire Base with D285 Smoke Head or D285TH Smoke Head with 135 degree heat sensor) reporting to the master address. The D298M is used over the D298S to conserve popit addresses on a large system.

FPA-1000, FPA-100-UL and FPA-1000-V2 - does not send restoral reports for events requiring a reset. The Reset Report is the Restoral.

Thanks to the latest AI technology and deep learning methods, the newest generation of fire detection cameras AVIOTEC 8000i IR becomes the best, fastest and more robust option for applications where traditional detectors might find limitations.

In the event of flames and smoke, the camera's built-in intelligent algorithms analyze the scene in real time by concatenating and transforming the input data. Deep learning AI directly analyses the data and if a fire is confirmed, it triggers an alarm and sends a signal either to the fire panel or the Video Management System.

AVIOTEC 8000i IR achieves an average of 3x faster detection times compared to current Aspirating Smoke Detectors*.

Typical application areas: Industrial manufacturing; Transportation: airports & railways; Logistics and warehouses; Parking: eMobility

This article provides instructions for troubleshooting Ground Fault in the FPD-7024 or D7024

How to interpret DBL when displayed on the FPD-7024 or D7024.

The FAA-325-B6S is to be used with the FAP-325, FAI-325 and FAH-325 model sensors only. The FAA-325-B6S provides an audible alarm in the immediate vicinity. Typical applications are for use in hotels, apartments, and hospitals. It is compatible with the FPA-1000, FPA-1000-UL, and FPA-1000-V2.

Morley Fire Panels D8024, D9024, D10024, and D10024A. Obsolete Morley printer module D9050. Panel replacement FPA-1000, FPA-1000-UL and FPA-1000-V2.

The cause of the error is combination of group address and the text length of the group label as defined in RPS as shown in this article

This article describes how to capture the panel/ controller communication log when requested by Technical support.

Panel controller displays can become de-calibrated, e.g. upon initial power-up followed by unintentional contact with the display or inaccurately touching the crosshairs.  It becomes noticeable after the panel controller has re-booted and does not respond properly to touch.

This article contains the RCP+ CGI commands for AVIOTEC starlight 8000 that helps you to enable or disable the scene quality (bright or dark)

This article contains the RCP+ CGI command for AVIOTEC starlight 8000 that helps you to adjust the VCA darkness or brightness level

This article answer if the labels or texts automatically updated in FSM after change in RPS.  

Is it possible to use complex maps on the FSM client? Recommendation is not to use very complex maps, very complex maps (means big size DWG files) can be made “lighter” by reducing the number of vertex (e.g. remove texts in DWG file and make rather use of the FSM text feature)

How to replace existing map or background on FSM client?

This article is a step by step guide about how to create panel container on map by using Macro-Area (point) on FMS.

This article answer to the question: " What is the maximum of simultaneous client connections supported on FSM?"