How to onboard a Bosch Camera in Genetec SC SaaS using Direct-to-Cloud (D2C) connectivity?

[#1]

Introduction

This article provides a step-by-step guide on how to onboard a Bosch camera to Genetec Security Center SaaS using Direct-to-Cloud (D2C) connectivity.

Prerequisites

• Camera of CPP-14 platfrom or newer
• FW 9.40 or newer

Onboarding to Genetec Securty Center SaaS via Direct to cloud (D2C)

1. Configure time sever on camera
   Go to Configuration → General → Date/Time.
   Set up the desired time server settings.
   
   
   
2. Enable Cloud services
   Navigate to Configuration → Connectivity → Cloud Services.
   Set Operations to "ON."
   Once successfully connected, the Connection State will update to "Available."
   
   
   
   
3. Connect camera to Bosch Vendor Cloud
   Select "Security Center SaaS"
   
   
   
   
4. Bosch Terms and conditions 
   Read and accept the Bosch Terms and Conditions (opens in a separate tab).
   
   
   
5. Region for Bosch Vendor Cloud
   Select the region to onboard the camera to the Bosch Remote Portal.
   Once onboarding is successful, the connectivity state will change to "Registered."
   
   
   
6. Onboard Camera to SC SaaS
   The necessary details (Serial Number and Device Secret) will be displayed for connecting to SC SaaS.
   Click the "Connect" button to initiate the connection from the camera.
   
   
   
   Add a Camera to SC SaaS
   Log in to your Genetec SC SaaS system.
   Navigate to Configuration → Add Device.
   Enter the device information by selecting Serial Number and Device Secret.
   
   
   
   Add a Bosch Camera
   Select the manufacturer: "Bosch".
   Enter the Name, Serial Number, and Secret, which can be found on the camera's webpage.
   Click "Add" to complete the process.
   
   
   
   
7. Configure and use your camera
   The camera has been successfully added to your system. You can now configure its settings (e.g., resolution, FPS) and begin using it.