Especially when using large databases it is advisable to make a backup occasionally in case something goes wrong. The manual describes ways to backup, restore and update the database quickly. This document describes how to use these options and when and also an alternative way for older versions.
When upgrading from a previous DICENTIS version that supports DANTE (V2.20 – V3.00) to the latest version 3.10, the following problem will occur; The DICENTIS system is not visible anymore in the Audinate’s DANTE controller software, where it was visible before the upgrade.
In order to change the layout, the StyleSheet needs to be changed. Default it is located in C:\ProgramData\Bosch\DICENTIS\VotingResult.xslt, this file can be opened in any text editor, Notepad++ is recommended as it is very versatile.
When using a fixed IP addresses in a multi-subnet Dicentis system, certain settings need to be made for the system to function well. If the settings are not made correctly, the system can stop functioning & disconnect from the server.
The APS in question was running on v1.12 and needed to be upgraded to v2.60 and any firmware updates would continually fail (even other intermediate versions). The below procedure is not specific to this update and can also be used for updating from other older versions.
Dicentis can run on a server with multiple network cards, but adding a variable that points to the network card that connects to the APS and other Dicentis equipment is required for it to work correctly.
Trouble mixing and matching older & newer Dicentis cable assemblies, cables and connectors. The problem is usually that the cables and connectors do not fit together correctly or it's very hard to put them together.
When trying to open the API demonstrator it will not open the demonstrator.
In version 3.11 it works but in 3.20 it will not.
Run the DCNM setup again and make sure that the option ‘(Default) Bosch DICENTIS API’ is also enabled.
Complete the installation and restart the PC.