Fire

In the controller history, you can see entry as detailed below, showing Detector -On- 14 , what does this indicate?

The following steps describe an efficient way to update the panel firmware in an AVENAR panel 4.x network via SD card, thus keeping downtime of the panels to a minimum. To further reduce downtime, it is recommended to network the panel nodes via ETH.

This article contains the FSM - Anomalies symbols and their description

To check Directx and graphics card capability you can use the dxdiag tool provided with Windows OS.

The table below shows the current FSM, FSI and MPC versions compatibility:  

This article provides instructions for exporting and saving the program from an FPA-1000 to be imported into a replacement FPA-1000 panel. This information may be needed when replacing an FPA-1000 fire panel with another with intentions to use the same panel program.

Part numbers DS240, DS241, D296, D297

This article provides an answer if the FAA-350 Popit Base is a direct replacement for the Older D290 Popit Base.

Thanks to the latest AI technology and deep learning methods, the newest generation of fire detection cameras AVIOTEC 8000i IR becomes the best, fastest and more robust option for applications where traditional detectors might find limitations.

In the event of flames and smoke, the camera's built-in intelligent algorithms analyze the scene in real time by concatenating and transforming the input data. Deep learning AI directly analyses the data and if a fire is confirmed, it triggers an alarm and sends a signal either to the fire panel or the Video Management System.

AVIOTEC 8000i IR achieves an average of 3x faster detection times compared to current Aspirating Smoke Detectors*.

Typical application areas: Industrial manufacturing; Transportation: airports & railways; Logistics and warehouses; Parking: eMobility

This article provides instructions for troubleshooting Ground Fault in the FPD-7024 or D7024

How to interpret DBL when displayed on the FPD-7024 or D7024.

The cause of the error is combination of group address and the text length of the group label as defined in RPS as shown in this article

This article describes how to capture the panel/ controller communication log when requested by Technical support.

Panel controller displays can become de-calibrated, e.g. upon initial power-up followed by unintentional contact with the display or inaccurately touching the crosshairs.  It becomes noticeable after the panel controller has re-booted and does not respond properly to touch.

This article contains the RCP+ CGI commands for AVIOTEC starlight 8000 that helps you to enable or disable the scene quality (bright or dark)

This article contains the RCP+ CGI command for AVIOTEC starlight 8000 that helps you to adjust the VCA darkness or brightness level

This article answer if the labels or texts automatically updated in FSM after change in RPS.