Security: Access Control

I cannot convert the ST1000 and get it to work on the D6600 receiver. ST-1000 software, D6200 software

What is a dialer error #6 and what are the possible causes ? SC4000, SC3100, SC2104, SC9000, D6690, D6695, D6200, ST-1000, RF2000  

Getting a dialer error # 1 what does this mean, and what causes it ? SC4000, SC3100, SC2104, D6690, D6695, D6200, ST-1000, SC900, RF2000

Getting a dialer error #2 at the central station.  What is this error and what causes it SC4000, SC3100, SC2104, D6690, RF2000, D6695, SC9000, ST-1000, D6200

We are getting a dialer error #3 at the central station, what causes the dialer error #3? SC4000, SC3100, SC2104, D6690, D6695, RF2000, SC9000, D6200, ST-1000

Central station is receiving a dialer error #4, what causes this error? SC4000, SC3100, SC2104, RF2000, D6690, D6695  

What is a dialer error #5 and what causes it ? SC4000, SC9000, SC3100, SC2104, D6690, D6695, ST-1000, D6200, RF2000

Unit has not communicated and the system status LED is blinking 1 red, pause, repeat. This would be an indicator of bad ROM check sum. SC2104  

SafeCom receiver generates an RF Trouble for a remote, but only when the Remote transmits an actual event to the SafeCom receiver. When events are no longer being transmitted and polls from the remote are received successfully, the RF Trouble restores until the next event is transmitted.  SC4000,SC2104,SC3000

What is  the part number for the powered wire harness for the SC2104 unit? SC2104

Safecom Dialer error message definitions SC9001

How long will the C472 transmitters stay keyed up before they stop transmitting, and how long does the transmitter have to wait before it can send signals again C472

I have phone supervision enabled on my C601. If a phone jack is left off-hook, the module eventually goes into phone line trouble. What voltage is the module looking for? C601

Which transmitter do I use for the MultiLink System? C472

What does uplink/downlink frequency mean? C601,C471,C472

How do I supervise the C8137 zone outputs when I tie them down to a C601 encoder C8137,C601