About rlarkins

 The error typically appears with "older" intrusion panels Perform the following steps: 1.  Make sure you are connecting to the panel in a way that panel model accepts.  If, for example, you were to try to use the Enhanced Direct method of communication to a D9112B, you would get the "subscript out of range" message. 2.  Disconnect all other devices off of the SDI BUS except for the device you are using to connect to RPS.  If this resolves the issue, reattach the other devices one-by-one and test with RPS until you find the one device that is causing the problem. 3.  Create a new panel in RPS and try to connect with that blank panel.  NOTE:  If you successfully connect with the blank panel record, do not choose the "send to panel" option as that will default your panel.  Either receive the data from the panel, or just disconnect.  If this resolves your issue, this may imply that your original panel record had become corrupt and should be rebuilt. 4. Verify the panel you created in RPS is the "correct" model of the actual panel. Ex: Create D9112 panel in RPS but actual panel is a D9112b1. ... View more

What conditions activates Relay 8 on the first reader board? Relay 8 is the common alarm output.  The Common Alarm is triggered from the following events occurring anywhere on the system: Door Forced Open Door Held Open Alarm from an Input Point AC Power Failure Keypad Duress  The common alarm output is reset after the event has cleared and the alarm event has been acknowledged in the transaction display of the web interface. ... View more

This is typically caused when the “Use or Lose Badge” feature is used without presenting the enrolled card to a reader within 24 hours. When using the feature “Use or Lose Badge” you must present the card to a reader on the system within the first 24 hour period or the selected number of days does not take effect and the cards are set to lost after Midnight. ... View more

This message typically means there were no other events generated within a defined event duration for a specific receiver account, "D6600 or D6100. These accounts are setup under System Administration, Additional Hardware and Receivers. These events are configured in an Event Code template that is assigned to a specific receiver account. ... View more

Here are the steps to perform this: 1) Configure the computer IP address in the range of 192.168.0.2 to 192.168.0.254, except for 192.168.0.251 as this address is the default IP address of the LNL-2220. 2) Connect the LNL-2220 to the computer using a crossover cable or hub. 3) Turn DIP switch 1 OFF, 2 ON, 3 OFF, and 4 OFF. 4) Cycle power to the LNL-2220. 5) Wait approximately 30 seconds for the panel to reboot. 6) Browse to the following address via Internet Explorer: http://192.168.0.251 7) Click on the link "Click here to login." 😎 Turn DIP switch 1 ON. 9) Log on to the Web configuration page with a user name of "admin" and a password of "password." 10) After you are logged onto the Web configuration page, configure the LNL-2220 as required. 11) Turn all DIP switches OFF. 12) Navigate to the Apply Settings page. 13) Click [Apply settings and reboot]. 14) Connect the LNL-2220 to its intended network, and then continue to configure it in System Administration. ... View more