Fire

This article explains is we can use Remote desktop to run or use the FSM client. When using remote desktop the error below will be shown when remote desktop is minimized and then maximized, the only option is to close the FSM client and start again.

This article explains step by step how to enable commands for operator (other than admin) in FSM

In this article you will find out the type of lens mount of AVIOTEC & the difference between C-mount/ CS-mount lenses

Part numbers DS240, DS241, D296, DD297

Part numbers FPP-RNAC-8A-4C, D7038, DS9484,

This article presents causes and solution about different detector symbols displayed at different clients in FSM. 

Part numbers FPD-7024, D7024, DS9400, DS9400I, DS9400M

This article contains the standard settings/ minimum detection size for smoke or flame of AVIOTEC IP starlight 8000

The controller is showing faults but when you access the faults option no errors/fault messages are shown, message 'no suitable element' is shown. Why?

Part numbers D7033, FMR-7033, DS9447

Part numbers FPD-7024, D7024, DS9400, DS9400I, DS9400M,

Follow this article and learn about the option which allows you to configure the color for each state & sensor in FSM

Live time event printing is supported. To enable it, add a xml file in program data folder with the name of the printer.

Find out in this article how many Remote Keypads can be set as automatic connection to one Controller (Bosch Fire Alarm Systems)

Thanks to the latest AI technology and deep learning methods, the newest generation of fire detection cameras AVIOTEC 8000i IR becomes the best, fastest and more robust option for applications where traditional detectors might find limitations.

This article answer to the question: "Can a fire alarm have the same sound as the one for a fault?"

A modification of the sensor group icon is possible but requires a different file naming than for detectors

Learn from this article how to enable usage type Fire on KD55 element from Bosch Remote Programming Software (RPS)

If the Item "Panel" is e.g. 1-1.1.1 respectively 1-1.SI_PANEL.1,then this item is the Group item of the panel system status items e.g. 1-1.1.1-1 till 1-1.1.1-10. Most of these system status items have NORMAL as value after startup, others can have ON, e.g. items from Condition Monitoring.

This feature blocks the programming feature through the keypad of the FPD-7024. This feature is only enabled via RPS.   Step-by-step guide   1 Connect to the Panel via RPS an Open the FPD-7024 programming sheet.   2 Go into Program Accounts and Remote Access Security.   3 Open Anti-takeover Setting and Select "Lock all local programming (except Date/Time and all user PINs)" to block the programming via keypad of the panel.