Installed Audio: Public Address

In the Praesideo logging you will see 'faultcode 255' as extra information belonging to a Cobranet error, what does this mean?

In the Praesideo logging you will see 'faultcode 1' as extra information belonging to a PRS-4OMI4 error, what does this mean?

Symptoms When using PRS-4OMI4 in a Praesideo system, there was a delay and jittering when they made an announcement from 1 NCO to the other NCO  Diagnosis The problem was caused by older OMNEO firmware within the OMI’s. Though the Praesideo software in the OMI’s was relatively up-to-date (4.37), the OMNEO firmware was not. Unfortunately, updating the Praesideo software through the optical bus does not also update the OMNEO firmware as this is a completely different path (OMNEO is updated through the Ethernet connection of the OMI). Solution   Due to some issues with OMNEO Firmware Update Tool v5.40 not working with unsigned firmware files (and the OMNEO firmware files are unsigned), it’s recommended to use OMNEO FWUT that comes with the Praesideo software folder. This version can be found on the Praesideo software folder then the folder 'Tools' , 'PRS-4OMI4 config tools'. Install the 'SetupOMNEOfirmwareUploadTool(64).msi'. Install the 'PRS-4OMI4 Network Firmware Vx.xx.xxxx.msi'. Open the OMNEO firmware upload tool. Select the PRS-4OMI4 units that needs the update. Click on 'Upload' Select the needed firmware file Click start.

When adding an NCO3 to a system running on NCO-Bs, either to expand the system or to replace an NCO-B, there are certain things to keep in mind.